数显角度测量仪 M-30L

安装要点:

传感器的信号线要远离动力线和接触器等强干抗设备。电源供电范围:交流或直流9~~24V,过高的电压可能会损坏本设备。传感器的安装面必须紧固在上下摆动的角位移面,并且要和摆动方向相同(见传感器上的标识)。
调试要点(必要的2步)
A、请检查设备的运行方向和测量显示方向是否一致,如果不一致,请将传感器的方向掉转
B、将设备调整到0度的位置,然后在此位置设置,将当前测量值清零

Install Essentials
Sensor signal cables away from power lines and interference equipment such as contactors. Scope of supply: AC or DC 9--24V, high voltage may damage the device Bobbingsensor mounting surface must be fastened at corners Moving surfaces, and swing in the same direction(see marks on the sensor).
Debugging points(need 2 step)
A, Check the running direction and measure the display orientation is consistent, if not, move the sensor direction turned
B, Adjust the device to O degree position, then this location is set, the current measured values to zero